3d Print What?!?!

I hope to design a 3d printed bow tie. For the past few years, I have been looking for a good bow tie. In that time I have gotten two, but I know that these are great articles of clothing. Bow ties have been known to be the epitome of  social clothing. Possible roadblock would probably be designing it because there are many ways you can design it and it can either be very easy, or very difficult. The dimensions should approximately be around 10 x 4.7 x 1.5 cm. The largest task will be to make sure that I finish up the design of it because that will be the most tricky. I would have to get these done by around the end of May, and maybe the very start of June, because it may also take longer to design based on its complexity.